By default, computers running Windows Server 2003 operating systems are configured as Dynamic Host Configuration Protocol (DHCP) clients, which means they can accept leases from any available DHCP server. TCP/IP computers (hosts) on a DHCP network automatically obtain TCP/IP configurations from DHCP servers that are located elsewhere on that network.
To configure TCP/IP for static addressing follow this procedure
Click on start–>Control Panel—>Network Connections.
Right-click the network connection you want to configure, and then click Properties.
On the General tab (for a local area connection) or the Networking tab (for all other connections), click Internet Protocol (TCP/IP), and then click Properties.
Click Use the following IP address, and do one of the following:
• For a local area connection, in IP address, Subnet mask, and Default gateway, type the IP address, subnet mask, and default gateway addresses.
• For all other connections, in IP address, type the IP address.
Click Use the following DNS server addresses.
In Preferred DNS server and Alternate DNS server, type the primary and secondary DNS server addresses.
Incoming search terms:
- static ip windows server 2003 (24)
- how to configure static ip in windows 2003 server (22)
- how to assign ip address in windows server 2003 (21)
- how to set static ip in windows server 2003 (17)
- assign static ip address windows server 2003 (17)
- windows server 2003 static ip (14)
- how to configure static ip in server 2003 (13)
- how to assign static ip in windows server 2003 (11)
- how to configure static ip in windows server 2003 (10)
- new static ip in windows server 2003 (9)